TTGuideTacoma manuals & technical reference
HomeAbout carFAQReviewLatestPopularManual indexSearchContacts
Toyota Tacoma (N220-N270, 2005–2015) Owners Manual / When trouble arises / Steps to take in an emergency

Toyota Tacoma (N220-N270, 2005–2015) Owners Manual: Steps to take in an emergency

  • If a warning light turns on or a warning buzzer sounds
  • If you have a flat tire
  • If the engine will not start
  • If the shift lever cannot be shifted from P (vehicles with an automatic transmission)
  • If you lose your keys
  • If the vehicle battery is discharged
  • If your vehicle overheats
  • If the vehicle becomes stuck
  • If your vehicle has to be stopped in an emergency
← Previous articleWhen trouble arises→ Next articleIf a warning light turns on or a warning buzzer soundsCalmly perform the following actions if any of the warning lights turn on or flash. If a light turns on or flashes, but then turns off, this does not neces…
Related Tacoma materials

Brake Switch "A" Circuit (P0571)
DESCRIPTION Detection condition 1: When the brake pedal is depressed, the stop light switch assembly outputs a signal to the ECM. When the ECM receives the signal, it cancels control of vehicle speed by the dynamic radar cruise control system. The fail-safe function operates to ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART If a trouble code is indicated while checking DTCs, inspect the circuit listed for that code in the table below, and proceed to the applicable page. Cruise Control System DTC Code Detection Item MIL See page ...

Installation
INSTALLATION PROCEDURE 1. INSTALL INTAKE MANIFOLD (a) Set 2 new No. 1 intake manifold to head gaskets on cylinder head sub-assembly and cylinder head LH as shown in the illustration. NOTICE: Align the port holes of the gasket and cylinder head sub-assembly ...

TTGuideToyota Tacoma manuals and technical documentation.
© 2011-2026 www.ttguide.net - 0.1046