Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

Toyota Tacoma (2015-2018) Service Manual / Supplemental Restraint Systems / Side Airbag Sensor(for Access Cab) / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

(a) Perform a Diagnostic System Check (See page 2. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and ).

2. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag has not Deployed)

CAUTION:

For side airbag sensor removal and installation procedures, see pages and , and carefully follow the correct procedure.

(a) Perform a Diagnostic System Check (See page (b) When the center pillar of the vehicle or its periphery is damaged, check ).

(b) When the center pillar of the vehicle or its periphery is damaged, check whether there is any damage to the side airbag sensor. If there are any defects, such as those mentioned below, replace the side airbag sensor with a new one:

Any cracks, dents or chips in the case.
Any cracks or other damage to the connector.
Peeling of the label or damage to the serial number.

3. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision)

CAUTION:

For side airbag sensor removal and installation procedures, see pages and , and carefully follow the correct procedure.

(a) Replace the side airbag sensor.

Components

COMPONENTS ILLUSTRATION ...

Installation

INSTALLATION CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See ...

Other materials:

USB Audio System Recognition/Play Error
DESCRIPTION When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by the navigation receiver assembly. This diagnosis procedure is for when a device is ...

Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects a +B short in the blind spot monitor indicator LH. DTC Code DTC Detection Condition Trouble Area C1AB0 With the blind spot monitor main switch assembly (warni ...

Chassis
General Maintenance GENERAL MAINTENANCE PROCEDURE 1. INSPECT STEERING LINKAGE (a) Check the steering wheel free play (See page ). (b) Check the steering linkage for looseness or damage. (1) Check that the tie rod ends do not have excessive play. (2) Check that the dust seals and boots are ...