TTGuideTacoma manuals & technical reference
HomeAbout carFAQReviewLatestPopularManual indexSearchContacts
Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Fuel / Fuel Injector(for Port Injection)

Toyota Tacoma (2015-2018) Service Manual: Fuel Injector(for Port Injection)

  • Components
  • Inspection
  • Removal
  • Installation
← Previous articleInstallationINSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the fuel injector assembly (See page ). PROCEDURE 1…→ Next articleComponentsCOMPONENTS ILLUSTRATION…
Related Tacoma materials

Pressure Sensor Circuit (B1423)
DESCRIPTION This DTC is stored if refrigerant pressure on the high pressure side is extremely low (176 kPa (1.8 kgf/cm2, 26 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2, 455 psi) or more). The air conditioner pressure sensor, which is installed on the pipe on the high pressure side ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. DTC CHECK USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes. (e) Check for DTCs. 2. DTC CLEAR USING TECHSTREAM (a) Conn ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab) Click here 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab) Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click here 4. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY Click here 5. REMOVE INSTRUME ...

TTGuideToyota Tacoma manuals and technical documentation.
В© 2011-2026 www.ttguide.net