COMPONENTS
ILLUSTRATION
ILLUSTRATION
Related Tacoma materials
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown.
If this happens, check and replace the fuses as necessary.
Turn the engine switch to the LOCK
position.
The fuses are located in the following
places. To check the fuses, follow the instructions below. ...
Charging Failure
PROCEDURE
1.
CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION)
(a) Start the engine and visually check if the fan of the generator rotor assembly
located inside the generator assembly is operating.
OK:
The fan of the generator rotor assembly is operati ...
Rear Axle Hub Bolt
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR AXLE HUB BOLT
(a) Install a new hub bolt through the axle hub.
(b) Install the washer plate, as shown in the illustration, through the hub bolt,
and install the hub bolt by tightening the hub nut.
2. APPLY HIGH TEMPERATURE ...