Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal.
The ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND DRIVER SIDE JUNCTION
BLOCK
(a) Remove the main body ECU (multiplex network body ECU) from the driver side
junction block (See page ).
(b) Disconnect the 1D driver side junction block connector.
(c) Measure the voltag ...
Master Cylinder Pressure Sensor Zero Point High Malfunction (C1422)
DESCRIPTION
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1422
Master Cylinder Pressure Sensor Zero Point High Malfunction
When vehicle speed is 3 km/h (2 mph) or more and stop light switch assembly
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY
(a) Engage the 3 claws to install the headlight dimmer switch assembly.
(b) Connect the connector.
2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
(See page ) ...
Rear Speed Sensor
Components