Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart

Fail-safe Chart

FAIL-SAFE CHART If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily. DTC Fail-safe Operation Fail- ...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. CHECK BATTERY CONDITION NOTICE: If the battery is weak or if the engine is difficult to start, recharge the battery and perform inspections again before return ...

Other materials:

Terminals Of Ecu
TERMINALS OF ECU CHECK ECM HINT: The standard voltage, resistance and waveform between each pair of the ECM terminals is shown in the table below. The appropriate conditions for checking each pair of the terminals is also indicated. The result of checks should be compared with the standar ...

Steering Angle Sensor Output Malfunction (C1434)
DESCRIPTION Steering angle sensor signals are input to the skid control ECU (brake actuator assembly) via the CAN communication system. HINT: When a malfunction occurs in the communication line to the steering angle sensor, U0126 is output. If a DTC related to the CAN communication line is ou ...

Installation
INSTALLATION PROCEDURE 1. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 1) (a) Apply engine oil to a new O-ring and install it to the camshaft timing oil control solenoid assembly in the locations shown in the illustration. Text in Illustration ...